TREADIVO.

Rolling out across Australia

Choose your location.
Back to blog

TPMS Explained: How Tyre Pressure Monitoring Works

Sketches of a tyre, sensor and pressure gauge

A tyre pressure monitoring system (TPMS) is the part of your car that warns you when a tyre has lost air. It watches the pressure for you and lights up a dashboard symbol when a tyre drops below a set level. Some systems measure pressure with a sensor inside each wheel. Others infer it from how fast each wheel spins. This guide covers both types, the rules in Australia, how long the sensors last and what to do when the light appears.

Treadivo
Find Tyres That Fit Your Car
Search by car model or tyre size, compare transparent pricing and choose a local fitter through Treadivo’s tyre shopping platform.
Explore tyre options

TL;DR

  • TPMS warns you when a tyre falls below a pre-set pressure, so you can top it up, swap to the spare or get to a tyre shop.
  • Direct systems use a sensor in each wheel. Indirect systems use the ABS wheel speed sensors and are generally less precise.
  • In Australia, ADR 107/01 requires TPMS on all new light vehicles from 1 November 2025.
  • Sensor batteries are sealed and typically last around 7 to 10 years. When one fails, the whole sensor is replaced.
  • If the light comes on, stop somewhere safe and check every tyre with a gauge. Do not ignore it.

Table of Contents

What TPMS is and what it does

The Tyre and Rim Association of Australia describes TPMS as a system designed to give a low-inflation warning when any tyre drops past a pre-set pressure. That gives you time to re-inflate the tyre, change to the spare or head to a tyre store before the problem gets worse.

It matters because most pressure loss is slow and invisible. A tyre can be well down on air and still look normal from the driver’s seat. Low pressure raises rolling resistance and heat, and it can leave the tyre unable to carry the load you are asking of it. TPMS does not replace a monthly check with a gauge. It covers the gap between checks, including the slow puncture you pick up on a Tuesday and would not otherwise notice until Saturday.

The warning is not a gauge reading. On most cars you get a symbol on the dash (often a horseshoe shape with an exclamation mark) rather than a number. Some cars also show the pressure for each tyre on the trip computer, but that depends on the system fitted.

What TPMS is and what it does

How TPMS detects low pressure

There are two ways to do it, and the difference shapes everything else in this guide: how accurate the warning is, how much it costs to maintain and whether there are batteries to run flat.

Direct and indirect TPMS compared by method and upkeep

On systems with sensors in the wheels, wireless sensors with internal batteries send readings to the car. Motion sensors mean they transmit mostly while you are driving, which helps save battery. When pressure falls by a set amount or percentage, the car gives visual and audible alerts.

On systems without wheel sensors, the car works it out from the ABS. A tyre that has lost air has a slightly smaller rolling radius, so it spins a little faster than the others. The software notices and raises the alarm.

Direct vs indirect TPMS

The Tyre and Rim Association of Australia explains that direct systems attach a pressure sensor and transmitter to each wheel, and an in-vehicle receiver warns you if any tyre falls below the set level. They are typically more accurate, and most can tell you which tyre is low. Indirect systems compare the rotational speed of one tyre against the others using the ABS wheel speed sensors.

Consumer group Choice gives the same picture: indirect systems deduce deflation from a wheel spinning faster, while direct systems measure pressure with wireless sensors in each wheel and send the data to a display.

Direct TPMS Indirect TPMS
How it measures Pressure sensor in each wheel Compares wheel speeds using ABS sensors
Tells you which tyre is low Usually yes No
Accuracy Higher Lower
Batteries Yes, in each sensor None of its own
Typical cost to the manufacturer Higher Lower
Fitted as Original equipment or aftermarket Original equipment only

The last row comes from the Tyre and Rim Association, which notes that the indirect type can only be offered as original equipment.

Where indirect systems fall short

The same source lists the weak spots. An indirect system will not say which tyre is low. It will not warn you if all four tyres are losing pressure at the same rate, which is what happens when temperatures fall in autumn and winter. And the alert can arrive after the tyre has already been rolling for some time on low pressure, which means a tyre that has gone flat can be damaged beyond repair by the time you are warned.

HELLA, an automotive electronics manufacturer, says indirect systems need a pressure loss of about 30% before a warning appears. The same page says direct systems are considerably more precise but cost more. The practical lesson is the same for both types: the light is a backstop, and your own gauge is the first line of defence.

Why carmakers use each type

Indirect systems are cheaper because they reuse parts already in the car. Only the ABS software and a dash display need adapting. Direct systems cost more but give you tyre-by-tyre information. If you are not sure which type your car has, look in the owner’s manual, or look for a small sensor stem on the inside of each wheel. A tyre shop can also tell you quickly when you book a fit.

Is TPMS compulsory in Australia?

For new cars, yes. Research on the Australian market reports that ADR 107/01 requires TPMS on new light vehicles: from November 2023 for new models, and from November 2025 for all new vehicles, in line with UN Regulation 141.

Two things follow for you as a driver:

  • A car built before those dates may have TPMS anyway, because many manufacturers fitted it earlier, particularly on higher-spec models. Plenty of older cars have none.
  • If your car came with TPMS, treat it as part of the safety equipment. Replacing worn sensors is a normal part of owning a car that has them.

If your car has no TPMS, aftermarket direct kits exist, such as cap-style sensors that screw onto the valves. They suit caravans, 4WDs and older vehicles, but the manual gauge habit still applies.

TPMS battery life and replacement

Direct sensors run on small sealed batteries. A manufacturer’s pocket guide puts the average life at 7 to 10 years, and says the batteries cannot be serviced. When the battery fails, the whole sensor needs replacing. An Australian market analysis suggests service lives of 5 to 8 years are more realistic for mandated modules, with replacement demand expected to pick up from about 2028 to 2030 as the first big group of ADR-mandated units ages.

In plain terms, plan on a sensor replacement somewhere between year five and year ten of the car’s life, depending on how many kilometres it does and how the sensors were built. High mileage drains batteries sooner, because the sensors transmit while you drive.

Signs a sensor battery is going

  • The TPMS warning light flashes for a minute or so at start-up and then stays on, even though all tyres are at the right pressure.
  • One wheel position stops reporting on a display that normally shows all four.
  • The warning appears intermittently without any change in tyre pressure.

These can have other causes, so a tyre shop should read the sensors rather than you guessing. Because the sensor sits inside the wheel, it makes sense to ask for any sensor checks when you already have a tyre off the rim, which saves a second visit.

What to do when the TPMS light comes on

The light is telling you at least one tyre is under-inflated. The Tire Industry Association says a yellow horseshoe symbol with an exclamation mark appears when pressure in one or more tyres falls below 25% of the recommended inflation, and that you should never ignore it because the tyre may not be able to support the load of the vehicle and its contents.

Here is a sensible order of play:

  1. Slow down and stop when it is safe. Goodyear’s advice, quoted by the motoring site Carma, is to stop as soon as it is safe and check the pressure of all your tyres with a gauge to find the one with the problem.
  2. Look at each tyre. A visible bulge, a nail or screw head, or a tyre that looks flat means do not drive on. Fit the spare or call roadside assistance.
  3. Check every tyre, including the spare if it is accessible. Use a gauge and compare with the pressures on the tyre placard, usually on the driver’s door jamb or in the owner’s manual.
  4. Inflate to the recommended pressure. Carma suggests heading to a service station and inflating to the recommended psi. Check the figure in your car’s own placard rather than guessing, as pressures vary between models and loads.
  5. Watch the light. If it clears after a short drive, you likely had a slow leak or a cold-morning drop. If it stays on, or returns within days, get the tyre inspected for a puncture.

If the tyre keeps losing air, do not keep topping it up and hoping. A tyre shop can find the leak, repair it where it is safe to do so, or replace the tyre.

Cold weather and the light

Tyre pressure falls as the temperature drops, which is why the light often appears on the first cold morning of the year. If you are heading to the cooler parts of Australia, or travelling overseas in winter, a winter car preparation checklist is a good prompt to check your tyres, battery and fluids together. Check pressures when the tyres are cold, before you drive, so the reading is not inflated by heat from the road.

When the light means a fault, not low pressure

The light does not always mean a low tyre. Carma notes that if the light will not go away after inflating, it could indicate a puncture or a malfunction in the TPMS sensor.

A few patterns point towards a system fault rather than air loss:

  • The light flashes at start-up and then stays lit. On many cars, a flashing then steady symbol points to a fault in the system rather than a low tyre. Your owner’s manual will confirm what your car does.
  • All four tyres are at the right pressure, but the light remains. A flat sensor battery, a damaged sensor or a communication problem are all possible.
  • The light came on after new tyres, a wheel swap or a rotation. On direct systems, each sensor is linked to a wheel position, and the car may need to relearn them.

In each case the fix is a visit to a tyre shop or workshop that can read the sensors. Do not rely on the light being wrong. Check the pressures by hand first, every time.

Our perspective

Most drivers meet TPMS twice: once as a mystery light on the dash, and again as a surprise line on a quote when a sensor needs attention. We think both moments should be easy.

The first step is knowing what the light means, and this guide is here for that. The second is making the fitting side simple. When you are buying tyres for a car with TPMS, the questions that matter are which tyre suits your vehicle, what the fitting involves and who does the work. We built Treadivo so you can search by car model or tyre size, see itemised pricing with no hidden fees and book a local fitter in a few minutes.

Our tools are there to take the guesswork out of choosing. The tyre size calculator helps you check a size before you order, the AI-powered tread check helps you judge how much life is left in the tyres you have now, and AR lets you see how a set will look on your car before you commit. A fitter confirms the booking the same day, so you are not left chasing a workshop.

Pressure monitoring and good tyres work together. A system that warns you early is most useful when the tyres underneath are in good condition and the right size for the car.

Areesh

Book your tyres and fitting with Treadivo

If your TPMS light has led you to a tyre that is past its best, we can help you sort it out. Search by car model or tyre size on our tyres page, compare options across passenger, SUV and 4x4, light truck and other categories, and choose a local fitter near you in Melbourne or Perth. Checkout takes about three minutes, and your fitting booking is confirmed by a local partner the same day.

Treadivo

If the tyres are fine but the car pulls to one side or wears unevenly, we also list alignment through the Treadivo home page. Prices are shown on the platform, itemised, before you pay.

Getting the most from TPMS day to day

A few habits keep the system useful:

  • Check pressures monthly with a gauge. TPMS is a safety net. It is not a substitute for a regular check, especially as an indirect system may not warn you about even loss across all four tyres.
  • Check the cold pressure on the placard. Use the figure for your car and your load, not the maximum printed on the tyre sidewall.
  • Check the spare. Some cars include the spare in the monitoring, and many do not. A flat spare is no use on the side of the road.
  • Mention TPMS when you book tyres. The wheel needs to come off the rim for a tyre change, and the sensor sits in the wheel. Letting the fitter know your car has TPMS helps them plan the job.
  • Keep a record of sensor age. If your car is approaching 7 years old and you are about to buy tyres, ask the fitter to check the sensors while the wheels are off. It is usually cheaper to replace an ageing sensor during a tyre change than on a separate visit.
  • Do not ignore a light that comes and goes. An intermittent warning is often the first sign of a slow leak or a sensor nearing the end of its life.

FAQ

What is TPMS?

TPMS stands for tyre pressure monitoring system. It is an electronic system that watches tyre pressure and warns you when a tyre drops below a pre-set level. It uses either sensors in the wheels or the ABS wheel speed sensors to do so.

What is the difference between direct and indirect TPMS?

Direct TPMS puts a pressure sensor in each wheel and can usually tell you which tyre is low. Indirect TPMS uses the ABS wheel speed sensors to spot a tyre spinning faster than the others, so it cannot say which tyre is affected. Direct systems are more accurate but cost more.

How long do TPMS batteries last?

The sensor batteries are sealed and cannot be replaced separately. One manufacturer’s guide gives an average of 7 to 10 years, while an Australian market analysis points to 5 to 8 years for mandated modules. When the battery fails, the whole sensor is replaced.

Can I drive with the TPMS light on?

Stop when it is safe and check all tyres with a gauge before going further. If a tyre is flat, visibly damaged or keeps losing air, do not drive on it. Fit the spare or call for help, and have the tyre inspected by a tyre shop.

Is TPMS mandatory in Australia?

On new vehicles, yes. ADR 107/01 applies to new models from November 2023 and to all new light vehicles from November 2025. Older cars may or may not have it, depending on the make and model.

Sources

Ready for new tyres?

Search your tyre size and see live prices, with fitting or pickup anywhere in Australia.