TREADIVO.

Rolling out across Australia

Choose your location.
Back to blog

Space Saver Speed Limit in Australia: How Fast and How Far

Hand drawn spare tyre speed limit title card

The usual space saver speed limit in Australia is 80 km/h. Some spares are rated lower, at 60 km/h, and the number that counts is the one on your spare and in your owner’s manual. Plan on roughly 80 to 100 km at most before you replace or repair the flat. Treat the spare as a way to reach a tyre fitter, not as a tyre to live on.

Treadivo
Get Back to the Right Tyres
Find tyres for your vehicle, compare transparent pricing and choose a local fitter when it’s time to replace your flat.
Find tyres and a fitter

TL;DR

  • Most space savers are limited to 80 km/h. Some are rated to 60 km/h, so check your own vehicle’s rating.
  • Keep the trip short. RAA says no more than 100 km, straight to a tyre specialist.
  • Slow down further in rain or on unsealed roads. Stopping distances grow and handling changes.
  • Check the pressure. Space savers typically need around 60 psi (420 kPa), far higher than a normal tyre.
  • Get the flat repaired or replaced as soon as you can, then put the spare away.

Table of Contents

What the speed limit on a space saver actually is

For most cars the answer is 80 km/h. WhichCar describes space savers as temporary replacements to get you to a repairer, and says you shouldn’t go faster than 80 km/h because the different size affects handling. NRMA gives the same figure, usually 80 km/h but it can vary, so follow the manufacturer’s guidelines.

Drive.com.au says space-saver spares are generally rated to 60 km/h or 80 km/h. That is why a blanket “80” is a ceiling, not a promise. If your spare says 60, 60 is your limit.

Where to find your number

  1. The sticker or sidewall of the spare. Many spares carry a speed warning printed on the wheel or a sticker on it.
  2. Your owner’s manual. It states the limit, the pressure and any distance guidance for your model.
  3. The boot or spare-wheel well. Some cars have a label there as well.

Australian design rules also require temporary-use spares to be marked. The 2007 tyre standard says they must carry the words “TEMPORARY USE ONLY”, and T-type spares must also state an inflation pressure of 420 kPa (60 psi). If your spare doesn’t carry those words, treat it with extra care and read the manual before you drive anywhere.

A quick reference

Question What Australian sources say
Typical maximum speed 80 km/h; some spares 60 km/h
Typical distance 80 to 100 km, sometimes quoted up to a few hundred km by rating
Inflation pressure Around 60 psi (420 kPa) for T-type spares
Wet or unsealed roads Drop well below the rated limit
Where to fit it Ideally on a rear wheel, per NRMA

Is the limit the law or a safety rating?

There are two things people mix up here.

The first is the road speed limit, which always applies. A space saver doesn’t give you a lower legal limit on a 100 km/h road. Your own limit is simply lower than the signs.

The second is the tyre rating. Under the Australian Light Vehicle Standards Rules, the rule requiring a tyre to be rated by its manufacturer for road use does not apply to a tyre used in an emergency as a temporary replacement (Rule 50). The same rules relax the ban on mixing tyres of different construction on one axle for emergency use (Rule 48). The ACT’s regulations carry a similar exemption, as do the Northern Territory’s vehicle standards rules.

In plain terms, the rules let you run a temporary spare to get out of trouble. They are not an invitation to keep driving on it. The practical speed ceiling comes from the manufacturer’s marking and instructions, so those are what you follow.

Why some experts say the tyre can go faster

Bridgestone Australia’s national technical field services manager, Jon Tamblyn, told Carsales that space savers are designed to be quite capable tyres and are often rated to 130 km/h. His main point is that the limit is there for driver safety. The real issue is stability: one tyre is different to the other three, which changes handling, cornering and stopping.

That is why you should treat the lower 80 km/h or 60 km/h figure as your working limit. The tyre may be strong, but your car is no longer balanced.

Practical speed ceilings compared with tyre rating

How far can you drive on a space saver?

The short answer is not far. Sources differ a little, so here is how they line up:

The wide range tells you the safe answer: use your manual’s figure if it has one, and otherwise aim to stay under 100 km. A roadside technician quoted by Drive.com.au points out that if you’re about 100 km from help on an 80 km/h spare, a tow can be the easier call. That is sensible in remote country.

How to drive on a space saver safely

The speed is only part of it. These habits matter as much.

Check the pressure first

A space saver runs at a much higher pressure than your normal tyres. Around 60 psi is typical, and the ADR labelling for T-type spares states 420 kPa (60 psi). Look at the label on your spare. Many spares sit for years, so check the pressure when you fit it. Use a servo air line or a portable compressor as soon as you can.

Driver checking a compact spare's pressure

Fit it where it does the least harm

NRMA suggests fitting the spare on a rear wheel where you can, because it grips less than a normal tyre, which reduces steering and stopping ability. If the flat is on a front wheel, check your manual. Some manufacturers have specific advice for front-drive cars.

Slow down more in poor conditions

Drive.com.au notes that stopping distances extend and handling is adversely affected, and that in rain or on unsealed roads you should reduce your speed even further below the rated limit. Leave a bigger gap, brake earlier and take corners gently.

Other sensible precautions

  • Keep the load light if you can, and don’t tow if the manual says not to.
  • Skip the car wash and avoid fitting chains. Both are commonly restricted for temporary spares, so confirm in your manual.
  • Take the shortest sensible route to a fitter, ideally one on suburban roads rather than a freeway.
  • If you’re on a 100 km/h road with an 80 km/h spare, move left, put the hazard lights on if traffic is much faster, and consider whether a tow is safer.

What to do once you’ve reached a fitter

A space saver buys you time, nothing more. Skip the Dealer says the same: it’s intended to get you to a workshop, not to replace your standard tyre permanently.

Once there, a fitter will check whether the original tyre can be repaired. Sidewall damage and some punctures can’t be fixed. Our guide to tyre sidewall damage explains how to inspect it and when replacement is the only safe option.

If you need a new tyre, the size must match your car. Our guide to finding the tyres that fit your car walks through the rego lookup. It’s also worth knowing your speed rating, because you should never fit a tyre with a lower rating than your vehicle needs.

If the other tyres are worn, replacing in pairs or as a set is often the neater fix. Our tyre age guide shows how to read the date code. Tyre Review Australia recommends that any tyre, main or spare, be inspected after 3 to 5 years for cracks and signs of ageing. That includes the spare that has lived in your boot since the car was new.

Space saver or full-size spare: what suits how you drive

Manufacturers fit space savers for good reasons. Drive.com.au lists more boot space, a third row of seats, a hybrid battery or a larger fuel tank, and says they also cut cost and weight. NRMA says space savers are safe and cost-effective if used to the manufacturer’s specifications. CarsGuide adds that many modern cars with huge wheels and tyres could not swallow a full-sized spare.

So for city and suburban driving, a space saver is a perfectly workable answer. The picture changes with distance. Drive.com.au says rural drivers who are often more than 80 to 100 km from a repair shop, or who regularly use 100 km/h country roads, should strongly consider a full-size spare. RAC WA agrees that people who take regular road trips to regional and remote areas may find a full-size spare the safer option.

If you do carry a full-size spare, it takes up boot space for good, so think about how often you’d really need it. Matching it to your other tyres also matters, and knowing the differences between summer, winter and all-season tyres helps you pick a spare that behaves like the rest. For 4x4s, our 4x4 tyre size guide helps you choose a spare that matches the rest of the set.

Perspective

Most of the people who contact a tyre fitter after a flat are in the same position: they’ve limped in on a spare, they’re a little shaken, and they want the car back to normal today. That is the right instinct, and it’s what we built Treadivo around.

Our view is simple. A space saver is a good piece of emergency kit, and the speed and distance limits exist to protect you. The best way to respect them is to shorten the time you spend on it. That means being able to search by car model or tyre size, see itemised pricing, pick a local fitter and book in a few minutes, rather than spending an afternoon on the phone.

We designed the platform for that moment. Same-day fitting confirmation is meant to get you off the spare quickly. Our AI-powered tread check tool and tyre size calculator are there so you can check the remaining tyres while you’re at it. If one tyre has failed, it’s worth knowing the condition of the other three.

Drive carefully on the spare, get to a fitter, and then get a proper tyre back on the corner.

Areesh

Get off the spare quickly

When you’re ready to replace the flat, you can shop tyres online at Treadivo. Search by your car model or tyre size, choose a local fitter near you and check out in about three minutes. Fitting is booked through the platform and confirmed by a local fitting partner. We aim to give same-day fitting confirmation.

Treadivo

If you’re in a capital city, you can go straight to tyre fitting in Melbourne or tyre fitting in Perth. Not sure of the size? Our tyre size calculator guide and tyre size equivalents guide explain what’s allowed in Australia.

FAQ

Can I drive at 100 km/h on a space saver?

No. Most space savers are limited to 80 km/h, and some to 60 km/h, so stay at or below the rating on your spare. Even where a tyre is rated higher, the mismatch with the other three wheels affects handling. Keep to the lower figure.

How far can I drive on a space saver?

Plan on 80 to 100 km at most. RAA says no more than 100 km, then straight to a tyre specialist. Your manual may give a different figure for your car, so follow that if it does.

Yes, as an emergency temporary replacement. The national Light Vehicle Standards Rules exempt tyres used in an emergency as a temporary replacement from the manufacturer-rating rule. Standard road speed limits still apply, and your own limit is the one on the spare.

Is it worth buying a space saver wheel?

For most city and suburban driving, yes. It saves boot space and weight. If you often drive more than 80 to 100 km from help or on country roads, consider a full-size spare instead.

Does a space saver affect braking and handling?

Yes. Stopping distances increase and handling changes, because one tyre is a different size from the other three. Fit it on a rear wheel where possible, leave extra room and slow down further in the wet.

Sources

Ready for new tyres?

Search your tyre size and see live prices, with fitting or pickup anywhere in Australia.